Наши популярные онлайн курсы
Let’s get started and make this learning experience fun. I call it the 5-week challenge. It started as a 5-day challenge, but obviously, it was impossible to implement in 5 days or even 10 days, so I renamed it 5-week challenge. Below is a series of challenges that take approximately 1 week each to help you integrate risk management into the decision making of your choice.
Week 1 – Choose the decision
- review board or executive committee minutes
- talk to the Board Secretary
- talk to Internal audit or risk colleagues to identify problem areas
- review management performance reports
Why do this? If you want to integrate risk management into decision making, you first have to choose a decision type or process where you will integrate into. Which decision is best? Something that you are familiar with, more importantly, something where you have a good relationship with the decision owner, who will let you pilot risk management. Preferably it should something with high visibility and something very material to the business.
Week 2 – Analyze the decision
- review decision-making process (documented or informal)
- review performance reports to see the results of decision making
- speak to the decision makers
- speak to internal audit
- speak to the decision stakeholders
Why do this? Once you have selected a decision, you need to find substance. You need to find out how the decisions are supposed to be done, how they were actually done, what were the results. At this stage, you want to collect as much ammunition as possible to use it next week.
Week 3 – Develop the methodology
- based on the selected decision choose the appropriate technique: decision trees (moderate), Monte-Carlo simulation (complex decisions) or scoring (simple decisions)
- the tool selection depends on the decision complexity, materiality, availability of data and time frame available risk analysis
- document the methodology
- seek feedback and validation from key stakeholders
Why do this? Once you have selected a decision, you need to propose an actual risk management tool/technique to integrate risk management into that decision making. If there is enough data, if the decision is done in excel, then Monte-Carlo simulation is the best choice. Here is a short video on how to integrate MC into strategic planning: https://www.youtube.
Week 4 – Pilot test the methodology
- select 2-3 past decisions and rerun them using the new draft risk analysis methodology. I hope you have selected decision trees or Monte-Carlo simulations or something better
- recalculate the pilot decisions
- present the preliminary results to key stakeholders involved in the decisions at the time
- adjust the methodology if necessary
- document the methodology
Why do this? Once you have selected a methodology, you have to test it to see if it adds any value to the decision makers, not too time consuming and there is sufficient data to perform calculations.
Week 5 – Roll out the new methodology
- once you updated the methodology based on the pilots, roll it out
- get it endorsed by the Risk Committee, looked at by the Audit Committee and approved by the management
- to roll out a methodology you will need to change existing business process procedures, train key personnel and provide ongoing support and quality control
That’s it! Well done! You’ve just integrated risk management into decision making.
